adverstisement



BORDEN INC -- INDUSTRIAL MAINT. & TOUCH UP SPRAY COLORS,2101 CHERRY RED. -- 8010-00-141-2952
=====================  Product Identification  =====================

Product ID:INDUSTRIAL MAINT. & TOUCH UP SPRAY COLORS,2101 CHERRY RED.
MSDS Date:01/04/1993
FSC:8010
NIIN:00-141-2952
MSDS Number: BVGYR
=== Responsible Party ===
Company Name:BORDEN INC
Address:180 E BROAD ST
City:COLUMBUS
State:OH
ZIP:43215-3705
Country:US
Info Phone Num:614-225-6124
Emergency Phone Num:216-292-7400
CAGE:07982
=== Contractor Identification ===
Company Name:BORDEN INC
Address:180 E BROAD ST
Box:208
City:COLUMBUS
State:OH
ZIP:43215-3705
Country:US
Phone:614-225-6124
CAGE:07982
Company Name:KRYLON PRODUCTS
Address:31500 SOLON ROAD
Box:City:SOLON
State:OH
ZIP:44139
Country:US
Phone:800-832-2541/216-566-2917
CAGE:87187

=============  Composition/Information on Ingredients  =============

Ingred Name:PROPANE (PROPELLANT)
CAS:74-98-6
RTECS #:TX2275000
Fraction by Wt: 18%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:1000 PPM
ACGIH TLV:ASPHYXIANT; 9394

Ingred Name:TOLUENE  (SARA III)
CAS:108-88-3
RTECS #:XS5250000
Fraction by Wt: 2%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:200 PPM; Z-2
ACGIH TLV:S, 50 PPM; 9394
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:ETHYL BENZENE  (SARA III)
CAS:100-41-4
RTECS #:DA0700000
Fraction by Wt: 2%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:100 PPM
ACGIH TLV:100 PPM/125STEL;9394
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:XYLENES (O-,M-,P- ISOMERS)	(SARA III)
CAS:1330-20-7
RTECS #:ZE2100000
Fraction by Wt: 8%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:100 PPM
ACGIH TLV:100 PPM/150STEL;9394
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:ACETONE  (SARA III)
CAS:67-64-1
RTECS #:AL3150000
Fraction by Wt: 37%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:1000 PPM
ACGIH TLV:750PPM/1000STEL;9294
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:METHYL ETHYL KETONE (2-BUTANONE) (MEK)  (SARA III)
CAS:78-93-3
RTECS #:EL6475000
Fraction by Wt: 8%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:200 PPM
ACGIH TLV:200 PPM/300STEL;9394
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:METHYL ISOBUTYL KETONE  (HEXONE)  (SARA III)
CAS:108-10-1
RTECS #:SA9275000
Fraction by Wt: 3%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:100 PPM
ACGIH TLV:50 PPM/75 STEL; 9394
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:VOLITILE ORGANIC CONTENT AS LISTED ON MSDS % BY WT PER
    BAAQMD RULE 49)
RTECS #:9999999VC
Fraction by Wt: 84%
Other REC Limits:NONE RECOMMENDED

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:NO
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:IRRIT OF EYES/SKIN/RESP TRACT. MAY
    CAUSE NERV SYS DEPRES. EXTREME OVEREXPOSURE MAY RESULT IN UNCONSC &
    POSSIBLE DEATH. PROLONGED OVEREXPOSURE TO SOLVENT INGRED MAY CAUSE
    ADVERSE AFFECTS TO LIVER, URIN ARY, BLOOD-FORMING, CARDIOVASCULAR,
    REPRODUCTIVE SYS. REPORTS ASSOCIATE PROL/REP EXPO OF SOLVENT W/PERM
    BRAIN/CNS DAMAGE
Explanation of Carcinogenicity:PER MSDS:NO INGREDIENTS IN THIS PRODUCT
    IS AN IARC/NTP/OSHA LISTED CARCINOGEN.
Effects of Overexposure:HEADACHE, DIZZINESS, NAUSEA, LOSS OF
    COORDINATION ARE INDICATIONS OF EXCESSIVE EXPOSURE TO VAPORS OR
    SPRAY MISTS. REDNESS & ITCHING OR BURNING SENSATION MAY INDICATE
    EYE OR EXCESSIVE SKIN EXPOSURE.
Medical Cond Aggravated by Exposure:NONE GENERALLY RECOGNIZED.

=======================  First Aid Measures  =======================

First Aid:INHAL:REMOVE FROM EXPOUSRE. RESTORE BREATHING. KEEP WARM &
    QUIET. SKIN:WASH AREA THOROUGHLY W/SOAP & WATER. REMOVE CONTAMIN
    CLOTHING. EYE:FLUSH W/LG AMTS OF WATER FOR 15MINS. GET MED ATTN.
    INGEST:GET	MED ATTN.

=====================  Fire Fighting Measures  =====================

Flash Point Method:PMCC
Flash Point:<1F,<-17C
Lower Limits:0.9
Upper Limits:13.1
Extinguishing Media:EXTREMELY FLAM, FLASH BELOW 21F. CARBON DIOXIDE,
    DRY CHEMICAL, FOAM.
Fire Fighting Procedures:FULL PROTECTIVE EQPMT INCLUDING SCBA SHOULD BE
    USED.WATER SPRAY MAY BE INEFFECTIVE.IF WATER USED FOG NOZ
    PREFERRED.COOL FIRE-EXPOSED CONTAINERS W/WATER.
Unusual Fire/Explosion Hazard:REMOVE FROM HEAT/ELECT EQPMT/ETC.CLSD
    CNTNR MAY EXPLODE WHEN EXPO TO EXTREME HEAT.APPLICATION TO HOT
    SURFACES REQ SPECIAL PRECAUTIONS.DECOMP PRODUCTS HEALTH HAZ

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITIN. VENTILATE AND
    REMOVE WITH INERT ABSORBENT.
Neutralizing Agent:NONE SPECIFIED BY MFG.

======================	Handling and Storage  ======================

Handling and Storage Precautions:USE ONLY W/ADEQ VENTI.AVOID BREATH
    VAP/SPRAY MIST & CONTACT W/SKIN/EYES.KEEP AWAY FROM HEAT/OPEN
    FLAMES.VAP ACCUMU FAST & MAY IGN EXPLOSIVELY.
Other Precautions:COATING MAY HAVE MATLS CLASSIFIED AS NUISANCE
    PARTICULATES WHICH MAY BE PRESENT AT HAZ LEVELS ONLY DURING
    SANDING/ABRADING OF DRIED FILM.IF NO SPECIFIC DUST LISTED
    APPLIACABLE LIMITS FOR NUISANCE DUST S ARE ACGIH TLV 10MG/M3,OSHA
    PEL 15MG/M3

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF PERSONAL EXPO CAN'T BE CONTROLLED BELOW
    APPLICABLE LIMITS BY VENTI WEAR NIOSH/MSHA APPROVED PROPERLY FITTED
    ORG VAP/PARTICULATE RESP FOR PROTECTION AGIANST INGREDS.SAND/GRIND
    DRIED FILM WEAR NIOSH/ MSHA APPROVED DUST/MIST RESP FOR (SUPPL)
Ventilation:LOC EXHA PREFERRED.GEN EXHA ACCEPTABLE IF EXPO TO MATL IS
    BELOW APPLICABLE EXP LIMITS.REFER TO OSHA STDS1910.94,107,108.
Protective Gloves:RESISTANT FOR LONG SKIN EXPOSURE.
Eye Protection:SAF SPECTACLES W/UNPERFORATED SIDESHIELD
Other Protective Equipment:NONE SPECIFIED BY MFG.
Work Hygienic Practices:WASH HANDS AFTER HANDLING. LAUNDER CONTAMIN
    CLOTHING PRIOR TO REUSE.
Supplemental Safety and Health
PRECAUTIONS:CONTENTS UNDER PRESSURE. DO NOT PUNCTURE/INCINERATE/EXPOSE
    TO HIGH TEMPS. USE APPROVED BONDING/GROUNDING PRACTICES. RESP:DUST
    GENERATED FROM MATL, UNDERLYING PAINT OR ABRASIVE.

==================  Physical/Chemical Properties  ==================

HCC:V3
Boiling Pt:B.P. Text:<0F,<-18C
Vapor Density:>AIR
Evaporation Rate & Reference:FASTER THAN ETHER.
Appearance and Odor:PER TIR:PRESSURIZED SPRAY CAN, RED.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:NONE SPECIFIED BY MFG. HOWEVER AVOID HIGH
    TEMPS & SOURCES OF IGNITION. APPLICATION TO HOT SURFACES REQ
    SPECIAL PRECAUTIO
Hazardous Decomposition Products:BY FIRE CARBON MONOXIDE AND CARBON
    DIOXIDE, OXIDES OF METALS IN INGREDIENTS SECTION.

====================  Disposal Considerations  ====================

Waste Disposal Methods:WASTE FROM MATL MAY BE HAZ UNDER RCRA
    40CFR261.WASTE MUST BE TESTED FOR IGNIT TO DETERMINE APPLICABLE EPA
    HAZ WASTE NOS.WASTE FROM MATLS HAVING METHYL ETHYL KETONE OR COPPER
    REQUIRE CARCINOCTILITY.DON 'T INCINERATE.DEPRESS CNTNR.DISPOSE OF
    IAW ALL REG

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.