adverstisement



INTERPLASTIC CORPORATION -- CORVE8710 VINYL ESTER RESIN -- 8040-00N020795
=====================  Product Identification  =====================

Product ID:CORVE8710 VINYL ESTER RESIN
MSDS Date:05/19/1989
FSC:8040
NIIN:00N020795
MSDS Number: BLRTJ
=== Responsible Party ===
Company Name:INTERPLASTIC CORPORATION
Address:2015 BROADWAY NE
City:MINNEAPOLIS
State:MN
ZIP:55413
Country:US
Info Phone Num:612-331-6850
Emergency Phone Num:800-424-9300 (CHEMTREC)
CAGE:16881
=== Contractor Identification ===
Company Name:INTERPLASTIC CORP
Address:2015 BROADWAY NE
Box:City:MINNEAPOLIS
State:MN
ZIP:55413
Country:US
Phone:612-331-6850
CAGE:16881

=============  Composition/Information on Ingredients  =============

Ingred Name:UNSATURATED POLYESTER RESIN; (UNSATURATED POLYESTER BASE
    RESIN)
Fraction by Wt: 55.0%

Ingred Name:STYRENE, MONOMER  (SARA III)
CAS:100-42-5
RTECS #:WL3675000
Fraction by Wt: 30.0%
OSHA PEL:100 PPM
ACGIH TLV:S,50PPM/100STEL;9293
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:DIVINYL BENZENE
CAS:1321-74-0
RTECS #:CZ9400000
Fraction by Wt: 8.5%
OSHA PEL:10 PPM
ACGIH TLV:10 PPM; 9192

Ingred Name:ETHYL STYRENE (ETHYL VINYLBENZENE)
CAS:28106-30-1
Fraction by Wt: 6.5%

Ingred Name:FIRST AID PROC: IF BRTHG IS DFCLT, ADMIN O*2. IF BRTHG HAS
    STOPPED, GIVE ARTF RESP. KEEP PERSON WARM, QUIET, (SEE ING 6)
RTECS #:9999999ZZ

Ingred Name:INGRED 5: AND GET MEDICAL ATTENTION.
RTECS #:9999999ZZ

Ingred Name:SPILL PROC:EXCLUDED FROM AREA OF SPILL UNTIL CLEAN-UP HAS
    BEEN COMPLETED. STOP SPILL AT SOURCE, DIKE AREA OF (SEE ING 8)
RTECS #:9999999ZZ

Ingred Name:INGRED 7: SPILL TO PVNT SPREADING, PUMP LIQ TO SALVAGE
    TANK. REMAINING LIQ MAY BE TAKEN UP ON SAND, CLAY, (SEE ING 9)
RTECS #:9999999ZZ

Ingred Name:INGRED 8: EARTH, FLOOR ABSORB/OTHER ABSORB MATERIAL AND
    SHOVELED INTO CONTAINERS.
RTECS #:9999999ZZ

Ingred Name:WASTE DISP METH: BE DISP OF I/A/W LOCAL, STATE AND FEDERAL
    REGULATIONS.
RTECS #:9999999ZZ

Ingred Name:RESP PROT: ENGINEERING OR ADMINISTRATIVE CONTROLS SHOULD BE
    IMPLEMENTED TO REDUCE EXPOSURE.
RTECS #:9999999ZZ

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:YES	 OSHA:NO
Health Hazards Acute and Chronic:EYES: CAN CAUSE SEVERE IRRIT, REDNESS,
    TEARING, BLURRED VISION. SKIN: PROLONGED OR REPEATED CONTACT CAN
    CAUSE MODERATE IRRITATION, DEFATTING, DERMATITIS. INHAL: EXCESSIVE
    INHAL OF VAPORS CAN CAUSE NAS AL IRRITATION, DIZZINESS, WEAKNESS,
    FATIGUE, NAUSEA, HEADACHE, POSSIBLE UNCONSCIOUSNESS, & EVEN (SEE
    EFTS OF OVEREXP)
Explanation of Carcinogenicity:STYRENE: GROUP 2B (IARC)
Effects of Overexposure:HLTH HAZ: ASPHYXIATION. INGEST: CAN CAUSE
    GASTROINTESTINAL IRRITATION, NAUSEA, VOMITING, DIARRHEA. ASPIRATION
    OF MATERIAL INTO LUNGS CAN CAUSE CHEMICAL PNEUMONITIS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

=======================  First Aid Measures  =======================

First Aid:SKIN: THORO WASH EXP AREA W/SOAP & H2O. REMOVE CONTAM CLTHG.
    LAUNDER CONTAM CLTHG BEFORE RE-USE. EYES: FLUSH W/LRG AMT OF H2O,
    LIFTING UPPER & LOWER LIDS OCCASIONALLY. GET MED ATTN. INGEST: DO
    NOT IND UCE VOMIT. KEEP PERSON WARM, QUIET & GET MED ATTN.
    ASPIRATION OF MATL INTO LUNGS DUE TO VOMIT CAN CAUSE CHEM PNEUM
    WHICH CAN BE FATAL. INHAL: IF AFFECTED, REMOVE INDIVIDUAL TO FRESH
    AIR. (SEE ING 5)

=====================  Fire Fighting Measures  =====================

Flash Point:88.0F,31.1C
Lower Limits:1.1%
Upper Limits:6.1%
Extinguishing Media:AQUEOUS FILM-FORMING FOAM CONSIDERED MOST
    EFFECTIVE, REGULAR FOAM OR CARBON DIOXIDE OR DRY CHEMICAL.
Fire Fighting Procedures:USE NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP .
    H2O/FOAM MAY CAUSE FROTHING WHICH CAN BE VIOLENT & POS ENDANGER
    LIFE OF FIREFIGHTER, ESPECIALLY (SUP DAT)
Unusual Fire/Explosion Hazard:VAPS ARE HVR THAN AIR & MAY TRAVEL ALONG
    GROUND/MAY BE MOVED BY VENT & IGNITED BY PILOT LIGHTS, OTHER
    FLAMES, SPARKS, HEATERS, SMOKING, ELEC MOTORS, (SUP DAT)

==================  Accidental Release Measures  ==================

Spill Release Procedures:SMALL SPILL: ABSORB LIQ ON PAPER, VERMICULITE,
    FLOOR ABSORBENT, OR OTHER ABSORB MATL & TRANSFER TO HOOD. LRG
    SPILL: ELIMINATE ALL IGNIT SOURCES (FLARES, FLAMES, INCLUDING PILOT
    LIGHTS, ELEC SPARKS). P ERSONS NOT WEARING PROT EQUIP SHD BE (SEE
    ING 7)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:CONTAINERS OF MATERIAL MAY BE
    HAZARDOUS WHEN EMPTIED.
Other Precautions:SINCE EMPTIED CONTAINERS RETAIN PRODUCT RESIDUES
    (VAPORS, LIQUID, AND/OR SOLID), ALL HAZARD PRECAUTIONS GIVEN IN
    THIS DATA SHEET MUST BE OBSERVED.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF TLV OF PROD/ANY COMPONENT IS EXCEEDED, A
    NIOSH/ MSHA APPRVD AIR SUP RESP IS ADVISED IN ABSENCE OF PROPER
    ENVIRONMENTAL CNTRL. OSHA REGS ALSO PERMIT OTHER NIOSH/MSHA APPRVD
    RESP UNDER SPECIFIED CNDT NS (SEE YOUR SFTY EQUIP SUP.)(SEE ING 11
Ventilation:PROVIDE SUFFICIENT MECH (GEN AND/OR LOCAL EXHAUST) VENT TO
    MAINTAIN EXPOSURE BELOW TLV(S).
Protective Gloves:NEOPRENE, NITRILE RUBBER GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NORMAL WORK CLOTHING COVERING ARMS AND LEGS.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
FIRE FIGHT PROC: IF SPRAYED INTO CNTNRS OF HOT, BURNING LIQ. EXPLO HAZ:
    STATIC DISCHARGE, OR OTHER IGNIT SOURCES AT LOCATIONS DISTANT FROM
    MATL HNDLG POINT. NEVER USE WELDING/CUTTING TORCH ON/NEAR DRU M
    (EVEN EMPTY) BECAUSE PROD (EVEN JUST RESIDUE) CAN IGNITE EXPLO.
    CNDTNS (STAB): 38C, 100F. CONTAM W/OXIDIZING AGENTS.

==================  Physical/Chemical Properties  ==================

HCC:F4
Boiling Pt:B.P. Text:SEE ING 2
Vapor Pres:SEE ING 2
Vapor Density:3.6
Spec Gravity:1.11-1.13
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:55

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:NO
AVOID CONTACT WITH: STRONG ALKALIES, STRONG MINERAL ACIDS AND OXIDIZING
    AGENTS.
Stability Condition to Avoid:EXPOS TO EXCESSIVE HEAT/OPEN FLAME;
    STORAGE IN OPEN CNTNRS; PRLNGD STORAGE (6 MONTHS), STORAGE ABOVE
    (SUPP DATA)
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE, LOW
    MOLECULAR WEIGHT HYDROCARBONS, ORGANIC ACIDS.

====================  Disposal Considerations  ====================

Waste Disposal Methods:SMALL SPILL: ALLOW VOLATILE PORTION TO EVAP IN
    HOOD. ALLOW SUFFICIENT TIME FOR VAPS TO COMPLETELY CLEAR HOOD DUCT
    WORK. DISP OF REMAINING MATL I/A/W APPLIC REGS. LRG SPILL: DESTROY
    BY LIQ INCINERATION  I/A/W APPLIC REGS. CONTAM ABSORB SHD (SEE ING
    10)

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.