adverstisement



CRAWFORD LABORATORIES, INC. -- MIL-C-22750 17038 BLACK PART A M8-093 -- 8010-01-419-1154
=====================  Product Identification  =====================

Product ID:MIL-C-22750 17038 BLACK PART A M8-093
MSDS Date:03/07/1996
FSC:8010
NIIN:01-419-1154
Kit Part:Y
MSDS Number: CBVJX
=== Responsible Party ===
Company Name:CRAWFORD LABORATORIES, INC.
Address:4165 SOUTH EMERALD AVENUE
City:CHICAGO
State:IL
ZIP:60609
Country:US
Info Phone Num:312-376-7132
Emergency Phone Num:800-424-9300
Preparer's Name:DAVID SCHMETTERER
CAGE:DO165
=== Contractor Identification ===
Company Name:CRAWFORD LABORATIES, INC
Address:4165 SOUTH EMERALD AVENUE
City:CHICAGO
State:IL
ZIP:60609
Phone:800-424-9300 CHEMTREC
CAGE:DO165
Company Name:CRAWFORD LABORATORIES, INC
Address:4165 SOUTH EMERALD AVENUE
Box:City:CHICAGO
State:IL
ZIP:60609
Country:US
Phone:312-376-7132
CAGE:5V430

=============  Composition/Information on Ingredients  =============

Ingred Name:METHYL ETHYL KETONE (2-BUTANONE) (MEK) (SARA III) (VP =
    71.2 MMHG)
CAS:78-93-3
RTECS #:EL6475000
Fraction by Wt: 14.0%
OSHA PEL:200 PPM/300 STEL
ACGIH TLV:200 PPM/300STEL 9192
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:TOLUENE (SARA III)
CAS:108-88-3
RTECS #:XS5250000
Fraction by Wt: 10.0%
OSHA PEL:100 PPM
ACGIH TLV:100 PPM
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:EPOXY RESIN
CAS:25085-99-8
Fraction by Wt: 24.0%
Other REC Limits:NONE RECOMMENDED

Ingred Name:NAPHTHA, LIGHT AROMATIC (VP = 9.0 MMHG)
CAS:64742-95-6
Fraction by Wt: 1.6%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:50 PPM
ACGIH TLV:50 PPM 9091

Ingred Name:SILICA, CRYSTALLINE - QUARTZ (MAY BE RELEASED BY SANDING
    DRIED PAINT FILM)
CAS:14808-60-7
RTECS #:VV7330000
Fraction by Wt: 16.0%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:NOT EST.
ACGIH TLV:0.1 MG/M3 RDUST;9495

Ingred Name:CARBON BLACK
CAS:1333-86-4
RTECS #:FF5800000
Fraction by Wt: 3.1%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:NOT EST.
ACGIH TLV:NOT EST.

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:YES	 OSHA:NO
Health Hazards Acute and Chronic:REPEATED/PROLONGED OCCUPATIONAL
    OVEREXPOSURE TO SOLVENTS ASSOCIATED W/PERMANENT BRAIN/NERVOUS
    SYSTEM DAMAGE. INTENTIONAL MISUSE BY DELIBERATELY CONCENTRATING AND
    INHALING THE CONTENTS MAY BE HARMFUL O R FATAL. PROLONGED
    OVEREXPOSURE (INHAL)MAY CAUSE DELAYED LUNG DISEASE.
Explanation of Carcinogenicity:FROM INITIAL LIMITED TESTS/STUDIES IARC
    CONCLUDES IS LIMITED EVIDANCE OF CARCINOGENICITY FROM CRYSTALINE
    SILICA.
Effects of Overexposure:OVEREXPOSURE MAY PRODUCE VARIOUS EFFECTS. ACUTE
    TOXICITY (HEADACHE, DIZZINESS, NAUSEA, LOSS CONSCIOUSNESS. SEVERE
    EYE IRRITATION POSSIBLY RESULTING PERMANENT DAMAGE. IRRITATED
    MUCOUS MEMBRANES. VOMITI NG FROM INGESTION. SKIN DEFATTING/DRYING.
    SENSITIZATION AFTER REPEATED CONTACT.

=======================  First Aid Measures  =======================

First Aid:EYE: FLUSH W/PLENTY CLEAN H20 15 MIN, LIFTING LIDS, GET MED
    ATTN. INHAL: GET FRESH AIR, PROVIDE OXYGEN IF BREATH DIFFICULT.
    GIVE ARTIF RESP IF NOT BREATHING. GET MED ATTN. KEEP VICTIM
    WARM/QUIET. NEVE R GIVE UNCONS PERSON LIQ. INGEST: CALL DR. IMMED.
    DON'T INDUCE VOMIT. IF VOMIT SPONTANEOUSLY, KEEP HEAD BELOW HIPS.
    SKIN: FLUSH W/H20 WHILE REMOVING CONTAM CLOTHES/SHOES. IF IRRIT
    PERSIST, GET MED AID

=====================  Fire Fighting Measures  =====================

Flash Point Method:SCC
Flash Point:22.0F,-5.6C
Lower Limits:1.4
Extinguishing Media:FOAM, CO2, OR DRY CHEMICAL
Fire Fighting Procedures:WATER MAY BE USED TO KEEP EXPOSED CONTAINERS
    COOL & KEEP FLAMMABLE STRUCTURE WETDON'T ENTER FIRE AREA WITHOUT
    PROPER PROTECTION, HAZARDOUS DECOMP MAY BE PRESENT
Unusual Fire/Explosion Hazard:WATER PRESSURE MAY SPREAD A FLAMMABLE
    LIQUID FIRE. SEALED CONTAINERS MAY EXPLODE IF OVER HEATED.

==================  Accidental Release Measures  ==================

Spill Release Procedures:WARNING - FLAMMABLE. ELIMINATE ALL IGNITION
    SOURCES. HANDLING EQUIPMENT MUST BE GROUNDED TO PREVENT SPARKING.
    SOAK UP WITHABSORBENT & PLACE IN NON-LEAKING CONATINERS. SEAL
    TIGHTLY FOR PROPER DISPOSAL.

======================	Handling and Storage  ======================

Handling and Storage Precautions:TREAT AS A HAZARDOUS-FLAMMABLE
    MATERIAL. KNOW APPLICABLE D.O.T. REG. BEFORE ATTEMPTING TO
    TRANSPORT THIS MATERIAL.
Other Precautions:WARNING: HOT ORGANIC CHEMICAL VAPORS OR MISTS ARE
    SUSCEPTIBLE TO SUDDEN SPONTANEOUS COMBUSTION WHEN MIXED W/AIR.
    IGNITION MAY OCCUR @ TEMPS BELOW THOSE PUBLISHED AS
    AUTOIGNITION/IGNITION TEMPS. IGNITI ON TEMPS DECREASE W/INCREASING
    VAPOR*

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IMPORTANT-MUST PROVIDE ADEQUATE VENT TO MAINTAIN
    VAPOR CONCENTRATE BELOW ESTAB- LISHED TLV LIMIT AS GIVEN BY OSHA.
    IN MORE CONFINED AREAS A NIOSH/MSHA APPROVED RESPIRATOR EQUIPPED
    WITH ORGANIC VAPOR C ARTRIDGE SHOULD BE WORN.
Ventilation:MUST PROVIDE ADEQUATE VENTILATION, SEE PARAGRAPH ABOVE.
Protective Gloves:USE RUBBER GLOVES
Eye Protection:APPROVED SAFETY GOGGLES &/OR FACE SHIELD
Other Protective Equipment:HAVE EYE BATH & SAFETY SHOWER AVAILABLE.
Supplemental Safety and Health
*VOLUME & VAPOR/AIR CONTACT TIME AND ARE INFLUENCED BY PRESSURE
    CHANGES. IGNITION MAY OCCUR AT TYPICAL ELEVATED TEMPERATURE PROCESS
    CONDITIONS, ESPECIALLY IN PROCESS OPERATING UNDER VACUUM IF
    SUBJECTE D TO SUDDEN INGRESS OF AIR, OUTSIDE PROCESS EQUIPMENT
    OPERATING UNDER ELEVATED PRESSURE IF SUDDEN ESCAPE OF VAPORS/MIST.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:175 TO 344F
Vapor Density:>AIR
Spec Gravity:1.15
pH:NA
Viscosity:>200 CENTISTO
Evaporation Rate & Reference:3.46 X N-BUTYL ACETATE
Solubility in Water:SLIGHT
Appearance and Odor:BLACK LIQUID, SOLVENT ODOR
Percent Volatiles by Volume:36.5

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
OXIDIZING AGENTS & STRONG ALKALIES. NOT CORROSIVE TO METAL.
Stability Condition to Avoid:HEAT, SPARKS, OPEN FLAMES, STRONG
    ALKALIES, & OXIDIZING AGENTS.
Hazardous Decomposition Products:INCOMPLETE COMBUSTION OR PRODUCTS LIKE
    THIS MAY GENERATE HIGHLY POISONOUS CARBON MONOXIDE AND OTHER TOXIC
    GASES

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSAL MUST BE IN ACCORDANCE WITH CURRENT
    LOCAL, STATE & FEDERAL REG. CONTACT AN APPROVED DISPOSAL FACILITY

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.